Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. BMW
    3. :
  3. Serie 3
    4. : How to remove and install the rear window seal on a BMW 3 Series

BMW Serie 3 - Video tutorial

Model: BMW Serie 3 E90, E91, E92 - Years 2005-2013
Part: Rear window
Operation: How to remove and install the rear window seal on a BMW 3 Series

How to remove and install the rear window seal on a BMW 3 Series? Don't worry, let's see how to proceed together in this video. Let's start the disassembly: we take a piece of rubber gasket and with a lever we follow the perimeter of the window (using leverage), we press and we move forward along the rear window track. We pull the rear window seal with the le, so as to detach it from the edge. Then, clean the perimeter of the rear window with a suitable liquid. Finally we press and spread the new gasket around the perimeter of the same. We check the correct insertion of the gasket in all points.


Posted on 23 October 2023 by ScegliAuto



BMW 3 Series gearbox selector oil seal replacement
BMW Serie 3 (1998-2006 / E46) Today's guide will show us the main steps to disassemble and replace the BMW 3 Series transmission selector oil seal. First, we lift the car and loca
How to remove and install the windshield seal on a BMW 3 Series
BMW Serie 3 (2005-2013 / E90, E91, E92) How to remove and install the windshield seal on a BMW 3 Series? Don't worry, let's see how to proceed with the removal together. Let's start the dis
Window lifter reset on BMW 3 Series E90
BMW Serie 3 (2005-2013 / E90, E91, E92) Let's see in this video how to reset the window control unit on a BMW 3 Series E90, fourth series, following the instructions below. First of all, le

How to reset the oil service in the Fiat Toro?

In this tutorial we can see how to reset the oil service in the Fiat Toro. Before carrying out this simple and quick operation, make sure that you have completed any required maintenance work. We start by inserting the key but leaving it in the initial position, after which we keep the accelerator pedal fully depressed and at the same time turn on the instrument panel. At this point, always keeping the accelerator pressed, press the brake pedal 5 consecutive times and, with the pedals in position, turn off the ignition. We check that the procedure has been successful by starting the vehicle.

Watch the video!


by ScegliAuto

More videos