Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. BMW
    3. :
  3. X3
    4. : Disassembly of the BMW X3 transmission

BMW X3 - Video tutorial

Model: BMW X3 MK 1, E83 - Years 2003-2010
Part: Transmission
Operation: Disassembly of the BMW X3 transmission

Today's guide will show us the main steps useful for disassembling and replacing the transmission of the BMW X3. First, we lift the vehicle and start by disconnecting the exhaust manifold near the transmission, unscrewing the clamps and also disconnecting the catalytic converter; then we remove the metal partition to access the transmission, as shown in the video. At this point, we unscrew the fastening screws of the drive shaft, separating it from the gearbox; then we remove the entire transmission, disconnecting the various wiring, following the video tutorial until the end!


Posted on 11 March 2024 by ScegliAuto



How to change transmission oil on BMW X3
BMW X3 (2003-2010 / MK 1, E83) The transmission oil must be changed at the km recommended by the house, let's see the replacement on BMW X3. We lift the car on a column bridge and
Driveshaft replacement instructions
BMW X3 (2003-2010 / MK 1, E83) Failure and / or wear of the transmission cardan joints result in a sort of snap that is felt mainly in the starting phase; in order to remove and re
Replacing the transfer case on the BMW X3 E83
BMW X3 (2003-2010 / MK 1, E83) In today's video tutorial we will see the main instructions for disassembling and replacing the transfer case on the BMW X3 E83. First we lift the ca

    Frequently Asked Questions

    • X3 2003-2010 - How much does it cost to replace the propeller shaft on the BMW X3? Read Answer

How to reset the oil service in the Fiat Toro?

In this tutorial we can see how to reset the oil service in the Fiat Toro. Before carrying out this simple and quick operation, make sure that you have completed any required maintenance work. We start by inserting the key but leaving it in the initial position, after which we keep the accelerator pedal fully depressed and at the same time turn on the instrument panel. At this point, always keeping the accelerator pressed, press the brake pedal 5 consecutive times and, with the pedals in position, turn off the ignition. We check that the procedure has been successful by starting the vehicle.

Watch the video!


by ScegliAuto

More videos