Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Motorcycles
    2. :
  2. Gasgas
    3. : Mc 65 : How to change the motor oil of a GasGas MC 65?

Model: Gasgas Mc 65
Part: Engine oil
How to change the motor oil of a GasGas MC 65?

To change the oil in a GasGas MC 65, start by placing the motorcycle on a flat and level surface. Remove the oil filler cap. Then, remove the oil drain plug and place a draining container underneath it. Once the oil is completely drained, screw the drain plug back on and tighten it securely. Fill the engine with new oil through the filler hole, using the recommended oil for your specific model. Refer to the owner's manual for the capacity and type of oil recommended. Once filled, start the engine for a few moments to allow the oil to circulate. Turn off the engine and check the oil level with the dipstick. Add oil if necessary to bring the level to the correct point. Finally, replace the filler cap and make sure all caps are securely tightened.


Posted on 1 May 2024 by ScegliAuto



How to change the motor oil of a GasGas MC 65?
Mc 65 To change the oil in a GasGas MC 65, start by placing the motorcycle on a flat and level surface. Remove the oil filler cap. Then, remove the oil dra
Assembling the starter motor on Gasgas EC 250-300
Ec 300 In today's video tutorial we will see how to install the starter motor on a Gasgas EC 250 and 300, following the instructions below. First of all, gr
How do you disassemble the starter motor of the GasGas EC 250?
Ec 250 In order to disassemble the starter motor of the GasGas EC 250, you need to first loosen the screws that secure the device to its housing, then disco

How to change the transmission oil of the Suzuki Burgman 400?

In order to replace the transmission oil of the Suzuki Burgman 400 you have to unscrew the screws that secure the transmission housing, positioned at the rear wheel on the left side of the bike. Once this cover has been removed, it will be possible to access the components in its lower part by unscrewing the transmission oil drain plug located next to the clutch. When all the oil has come out of this vent, it will be possible to collect it inside a container and insert the new one using a special syringe to be inserted in the same hole.

Watch the video!


by ScegliAuto

More videos