Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Motorcycles
    2. :
  2. Honda
    3. : Gold Wing 1500 : Oil change and oil filter on Honda Gold Wing 1500

Model: Honda Gold Wing 1500
Part: Checks and maintenance
Oil change and oil filter on Honda Gold Wing 1500

Warm up the engine for a few minutes before the procedure, in order to make the oil less viscous and therefore more liquid, favoring its subsequent leakage. For the same reason, first unscrew the top cap of the engine oil compartment in order to avoid vacuum. The oil drain bolt, which as you can see in the video is obviously located under the bike, can be unscrewed with a 17 socket wrench. The oil filter is located behind the front wheel and can be unscrewed with a 65 mm filter wrench . Lubricate the O-R of the new filter before fitting it. After draining the oil and changing the filter, tighten the drain bolt and load the new lubricant into the compartment and replace the cap.


Posted on 17 January 2024 by ScegliAuto



Oil change and oil filter on Honda Gold Wing 1500
Gold Wing 1500 Warm up the engine for a few minutes before the procedure, in order to make the oil less viscous and therefore more liquid, favoring its subsequent l
How to reset the oil service in the RAM 1500?
RAM 1500 (2009-2019 / MK 4, DS, DJ) Resetting the oil change light in the RAM 1500 pick-up is very simple, let's see how to proceed in this tutorial. Obviously, before following this pr
How to change the engine oil of a Chevrolet Silverado 1500
Chevrolet Silverado (1998-2007 / MK 1) In this video we see how to change the engine oil on a Chevrolet Silverado 1500. Let's start by removing the oil cap and lifting the car. Under the v

How to replace the Peugeot Viva City starter gear

Today we will see, in this video tutorial, how to disassemble and replace the starter gear of the Peugeot Viva City scooter. First of all we put our scooter on the central stand and we begin to unscrew the fixing screws located on the sides of the transmission side casing, in order to remove it; after which we unscrew the central nut of the fan, removing it and thus accessing the gear, as shown in the video. At this point we replace the starter gear with the new one, with the original spare; then we reassemble the fan and the clutch housing, applying the reverse procedure!

Watch the video!


by ScegliAuto

More videos