Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Motorcycles
    2. :
  2. Kymco
    3. : S 125 : How to change the time on the display of the Kymco S-125

Model: Kymco S 125
How to change the time on the display of the Kymco S-125

On our Kymco scooter, when the battery is low, or is changed, the display shows a wrong time. To adjust it, we turn on the panel, insert the total odometer by pressing key two and go to "odo" mode. We keep keys 1 and 2 pressed at the same time. At this point the hour flashes, press key 2 until it reaches the desired time. Press key 1, the minutes flash and we adjust those too (by holding it down, the minutes run faster). We release all the keys and wait a moment. At this point the time is confirmed by itself by remaining on the display.


Posted on 21 May 2024 by ScegliAuto



How to change the time on the display of the Kymco S-125
S 125 On our Kymco scooter, when the battery is low, or is changed, the display shows a wrong time. To adjust it, we turn on the panel, insert the total od
How to set the time of the Kymco Agility 125
Agility 125 In the following guide dedicated to your Kymco Agility 125 we will discover together how to manually set the time by simply using the buttons on the
How to reset the service light on the Kymco People S 125
People S 125 In the following guide we will describe a simple and effective method that will allow you to reset the service light of your Kymco People S 125 in a

How to remove the stator of the Peugeot Speedfight 2

Today we will see, in this video tutorial, how to disassemble and replace the stator of the Peugeot Speedfight 2 scooter, following these simple steps. In this case, the disassembly operation is carried out with the engine removed from the bodywork; then, once the rotor has been removed, we can go and unscrew the fixing screws of the stator, in order to remove it from the engine casing together with the electrical wiring, as shown in the video. At this point we are going to replace the component with the new one, with the original spare part; we install the stator in the correct direction, finally adjusting the advance.

Watch the video!


by ScegliAuto

More videos