Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Nissan
    3. :
  3. Qashqai
    4. : How do you replace the lambda sensor of the Nissan Qashqai?

Nissan Qashqai - Video tutorial

Model: Nissan Qashqai J11 - Years 2014-2022
Part: Lambda sensor
Operation: How do you replace the lambda sensor of the Nissan Qashqai?

To replace the lambda probe, you need to access the lower part of the device so that you can locate the end of the exhaust pipe: here you will find the lambda probe directly connected to the muffler. The device can be removed from its seat by loosening the nut that holds it, and then the appropriate connector can be disconnected. In this way, it will be possible to insert the new probe into its housing, connecting its connector and fixing it again to its housing with the appropriate nut that was previously removed.


Posted on 4 September 2023 by ScegliAuto



Deactivate Nissan Qashqai start & stop system 2
Nissan Qashqai (2014-2022 / J11) In this video we will see the instructions to permanently deactivate the start & stop system on a second series Nissan Qashqai. First we open the bon
How to remove the start and stop sensor of a Nissan Qashqai
Nissan Qashqai (2014-2022 / J11) Let's see together how to remove the start and stop sensor of a Nissan Qashqai. Let's open the bonnet, lift it up and put it in safety. Using a screw
Where is the oxygen sensor located on the Nissan Qashqai 1.6 dCi 130 Hp?
Nissan Qashqai (2014-2022 / J11) In this video, we see where the oxygen sensor is located on the Nissan Qashqai 1.6 dCi 130 Hp. This operation should be done when the orange engine m

How to reset the oil service in the Fiat Toro?

In this tutorial we can see how to reset the oil service in the Fiat Toro. Before carrying out this simple and quick operation, make sure that you have completed any required maintenance work. We start by inserting the key but leaving it in the initial position, after which we keep the accelerator pedal fully depressed and at the same time turn on the instrument panel. At this point, always keeping the accelerator pressed, press the brake pedal 5 consecutive times and, with the pedals in position, turn off the ignition. We check that the procedure has been successful by starting the vehicle.

Watch the video!


by ScegliAuto

More videos