Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Renault
    3. : R21 : Replacing the front brake pads

Renault R21 - Video tutorial

Model: Renault R21 MK 1 - Years 1986-1995
Part: Brake pads
Operation: Replacing the front brake pads

Loosen the wheel nuts and lift the car to secure it. Unscrew the bolts and remove the wheel. Disconnect the electric cable. Unscrew the two screws holding the caliper and remove it. Check the wear of the stops and piston. Clean the entire braking unit with alcohol and a brush and dry with compressed air. Grease the fixing pins and reposition the piston making sure it works properly. Fit the new pads paying attention to the direction of rotation and installing the one with contacts towards the inside. Refit the caliper and reconnect the electric cable. Make sure that the pads adhere perfectly to the disc. Recheck the regular brake fluid level. Re-establish the position of the pistons by acting on the brake pedal.


Posted on 24 June 2023 by ScegliAuto



Replacing the front brake pads on the Yamaha FZ 09
Fz 09 Let's see in this video how to remove and replace the front brake pads on the Yamaha FZ 09 (FZ9), following these simple steps. First of all, let's u
Replacing the brake pads in the Moto Guzzi V7
V7 Classic To replace the brake pads in the Moto Guzzi V7, first of all we place the motorcycle on the stand firmly fixed on a plane. Once this is done, we begi
How do you replace the brake pads on the Yamaha Tà © nà © rà ©?
Tenere 700 The procedure for replacing the Yamaha Tà © nà © rà © brake pads is the same for both the front brake and the rear brake. It is necessary to remove t

How to reset the oil service in the Fiat Toro?

In this tutorial we can see how to reset the oil service in the Fiat Toro. Before carrying out this simple and quick operation, make sure that you have completed any required maintenance work. We start by inserting the key but leaving it in the initial position, after which we keep the accelerator pedal fully depressed and at the same time turn on the instrument panel. At this point, always keeping the accelerator pressed, press the brake pedal 5 consecutive times and, with the pedals in position, turn off the ignition. We check that the procedure has been successful by starting the vehicle.

Watch the video!


by ScegliAuto

More videos