Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Motorcycles
    2. :
  2. Sym
    3. : Sym Elite 50 : How to change the engine oil on a Sym Elite 50?

Model: Sym Sym Elite 50
Part: Engine oil
How to change the engine oil on a Sym Elite 50?

To change the engine oil on a Sym Elite 50, start by placing the scooter on a flat surface and make sure the engine is warm, not hot. Locate the oil drain plug on the engine and place a collection container underneath it. Unscrew the drain plug and let the used oil drain into the container. Once the draining is complete, screw the drain plug back in. Next, locate the oil fill cap on the engine and remove it. Use a funnel to pour the new oil into the reservoir, being careful not to exceed the recommended level. Once the new oil has been added, screw the fill cap back in. Make sure both caps are securely tightened. Start the scooter for a few minutes to allow the oil to circulate in the engine. Finally, turn off the scooter, and you will have completed the oil change.


Posted on 19 April 2024 by ScegliAuto



How to change the engine oil on a Sym Elite 50?
Sym Elite 50 To change the engine oil on a Sym Elite 50, start by placing the scooter on a flat surface and make sure the engine is warm, not hot. Locate the oil
How do you change the engine oil of the Sym Jet14 200?
Jet 14 150 In order to change the engine oil of the Sym Jet14 200 you have to go to the lower part of the bike, at the height of the muffler: here you will find
Oil change on Sym NH-X 125
Nh X 125 On Sym NH-X 125 a sensor detects when it is time to change the engine oil and sends you the relative warning light that will appear on the frame of t

How to remove the stator of the Peugeot Speedfight 2

Today we will see, in this video tutorial, how to disassemble and replace the stator of the Peugeot Speedfight 2 scooter, following these simple steps. In this case, the disassembly operation is carried out with the engine removed from the bodywork; then, once the rotor has been removed, we can go and unscrew the fixing screws of the stator, in order to remove it from the engine casing together with the electrical wiring, as shown in the video. At this point we are going to replace the component with the new one, with the original spare part; we install the stator in the correct direction, finally adjusting the advance.

Watch the video!


by ScegliAuto

More videos