Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Toyota
    3. :
  3. Highlander
    4. : How to disassemble the rear seats of the Toyota RAV4

Toyota Highlander - Video tutorial

Model: Toyota Highlander Xu40 - Years 2008-2013
Part: Seat
Operation: How to disassemble the rear seats of the Toyota RAV4

Today we will see the instructions that will allow us to disassemble and replace the rear seats of the Toyota Highlander, following these simple steps. First, we open the rear doors of the vehicle and start pulling the rear seat upwards to detach and remove it; then we unscrew all the fixing screws of the backrests, opening the rear hatch of the trunk to access them, as shown in the video. At this point, we will significantly increase the cargo volume of the trunk; we reassemble the seats to put everything back in its original position, applying the reverse procedure!


Posted on 14 May 2024 by ScegliAuto



How do I replace the Toyota Highlander fuel pump?
Toyota Highlander (2008-2013 / Xu40) In order to replace the Toyota Highlander fuel pump you have to push the front seats forward, so that you can go to raise the carpet of the floor bet
How to replace the rear light bulbs of the Toyota Highlander
Toyota Highlander (2001-2007 / Xu20) Through these short and simple instructions, we will see how to disassemble and replace the bulbs of the rear headlight of the Toyota Highlander. Fir
How to disassemble the taillights in the Toyota Highlander?
Toyota Highlander (2020-2024 / Xu70) In this tutorial we can see how to disassemble the rear lights on a Toyota Highlander, a very simple operation to do if we need to replace a bulb or

How to reset the oil service in the Fiat Toro?

In this tutorial we can see how to reset the oil service in the Fiat Toro. Before carrying out this simple and quick operation, make sure that you have completed any required maintenance work. We start by inserting the key but leaving it in the initial position, after which we keep the accelerator pedal fully depressed and at the same time turn on the instrument panel. At this point, always keeping the accelerator pressed, press the brake pedal 5 consecutive times and, with the pedals in position, turn off the ignition. We check that the procedure has been successful by starting the vehicle.

Watch the video!


by ScegliAuto

More videos