Do it yourself
Frequently asked questions about cars and motorcycles

Volkswagen Polo - Arm

Volkswagen Polo (2001-2009 / Polo4, MK IV, 9N, MK 4, Poloiv)
How do you replace the front wheel silent block of the Volkswagen Golf?

In order to replace the silent block of the Volkswagen Polo, first you need to loosen the bolts that secure the wheel corresponding to its hub, removing it …read all…
Posted on 11 September 2023 by ScegliAuto
Volkswagen Polo (2009-2017 / 6R, Polov, MK V, MK 5, Polo5)
Replacement swing arm on Volkswagen Polo wheel

Loosen the 17 bolts of the affected wheel, lift the car with a jack (if you do not have the bridge) and remove the same. Use a wire brush and the WD40 to clean …read all…
Posted on 2 January 2024 by ScegliAuto
Volkswagen Polo (1994-2003 / MK 3, Polo3, 6N, MK III, Poloiii)
Replacement of the stabilizer bar support rubber

The failure of the stabilizer bar support rubbers is a very recurring failure and the symptom is a marked noise especially when driving on bumpy roads; …read all…
Posted on 20 August 2023 by ScegliAuto

Airbags (16) Alternator (4) Loudspeaker (2) Shock absorbers (3) Antenna (7) Air conditioning (2) Car stereo (36) Battery (26) Coil (3) Air Vents (7) Arm (3) Gearbox (3) Spark plugs (12) Glow plugs (2) Bodywork (6) Glove box (4) Control unit (2) Key (38) Locking the trunk (1) Timing belt (35) V-belt (4) Air conditioning controls (1) -board computer (29) Checks and maintenance (224) Throttle body (2) Dashboard (11) Gearshift gaiter (2) Bearing (4) Brake discs (3) Side indicator light (1) Headlight (34) Tail light (16) Fog lights (8) Particulate filter (1) Air filter (28) Cabin air filter (24) Petrol filter (4) Diesel filter (8) Oil filter (6) Hand brake (11) Clutch (1) Grille (3) Injectors (4) Window lift switch (2) Accessory Kit (1) Light bulb (16) Side turn signal light bulb (3) Headlight bulb (42) Rear light bulb (18) Interior lights ceiling light bulb (10) Antifreeze liquid (2) Dashboard light (2) License plate light (5) Third brake light (1) Handle (9) Mask (1) Engine (2) Window motor (4) Starter motor (7) Power Steering Motor (1) Gear oil (1) Engine oil (12) Power steering oil (1) Door panel (38) Windshield (1) Front bumper (10) Rear bumper (6) Brake pads (6) Hydraulic pistons (1) Tires (8) Gear Shift Knob (6) Pump (7) Fuel pump (4) Door (11) Push button (3) Window lift button (1) Instrument cluster (50) Radiator (3) Passenger compartment heating radiator (4) Wheel (4) Fuse box (73) Seat (15) Crankshaft RPM sensor (6) Coolant temperature sensor (3) Lock (18) Lambda sensor (1) Outside rearview mirror (17) Manufacturer's coat of arms (2) Drums and shoes (1) Windscreen wipers (16) Thermostat (6) Engine head (1) Central tunnel (2) Windshield washer nozzle (2) Valve (1) EGR valve (4) Interior blower (12) Side window (1) Steering wheel (16)

How to reset the oil service in the Fiat Toro?

In this tutorial we can see how to reset the oil service in the Fiat Toro. Before carrying out this simple and quick operation, make sure that you have completed any required maintenance work. We start by inserting the key but leaving it in the initial position, after which we keep the accelerator pedal fully depressed and at the same time turn on the instrument panel. At this point, always keeping the accelerator pressed, press the brake pedal 5 consecutive times and, with the pedals in position, turn off the ignition. We check that the procedure has been successful by starting the vehicle.

Watch the video!


by ScegliAuto

More videos