Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Volkswagen
    3. :
  3. Golf
    4. : How to disassemble the accelerator pedal in the Volkswagen Golf?

Volkswagen Golf - Video tutorial

Model: Volkswagen Golf Golf VI, Golf 6, MK 6, 5K1 - Years 2008-2012
Part: Accelerator
Operation: How to disassemble the accelerator pedal in the Volkswagen Golf?

In this tutorial, we can see how to disassemble the accelerator pedal in the Volkswagen Golf, a very simple and fast operation. First of all, position yourself on the driver's side, then remove the indicated plastic cap, located to the left of the pedal, and unscrew the newly released bolt. Once this is done, insert two small flat-tipped screwdrivers under the front edge of the base, unlock the fixing clips, and separate the pedal from the support. Finally, disconnect the control cable and follow the reverse procedure to install the replacement if necessary.


Posted on 15 August 2023 by ScegliAuto



How to replace the accelerator pedal of the Volkswagen Golf.
Volkswagen Golf (2008-2012 / Golf VI, Golf 6, MK 6, 5K1) Let's see the necessary instructions on how to disassemble and replace the accelerator pedal of the Volkswagen Golf, in simple steps. First of all, l
How to reset the accelerator pedal of the Volkswagen Golf
Volkswagen Golf (2003-2008 / Golf 5, MK 5, Golf V) In this short video we will see the steps on how to reset the accelerator pedal response of the Volkswagen Golf, but also of the Jetta, following the
How to disassemble the Volkswagen Golf clutch pedal master cylinder
Volkswagen Golf (2008-2012 / Golf VI, Golf 6, MK 6, 5K1) We see in this guide the main instructions on how to disassemble and replace the master cylinder or the clutch pedal pump of the Volkswagen Golf. Fir

    Frequently Asked Questions

    • Golf 2019-2026 - When to make the first service on the VW Golf 8? Read Answer

How to reset the oil service in the Fiat Toro?

In this tutorial we can see how to reset the oil service in the Fiat Toro. Before carrying out this simple and quick operation, make sure that you have completed any required maintenance work. We start by inserting the key but leaving it in the initial position, after which we keep the accelerator pedal fully depressed and at the same time turn on the instrument panel. At this point, always keeping the accelerator pressed, press the brake pedal 5 consecutive times and, with the pedals in position, turn off the ignition. We check that the procedure has been successful by starting the vehicle.

Watch the video!


by ScegliAuto

More videos