Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to replace the bulb of the rear interior light of the Audi A6

Model: Audi A6 MK 3, C6 - Years 2004-2012
Part: Interior dome light bulb

In this short guide, we will see the instructions that will allow us to disassemble and replace the bulb of the rear interior light of the Audi A6. First, open the rear hatch of the trunk and start levering on the side of the light to detach and remove it; remove the side clips to access the two bulbs inside, as shown in the video. At this point, remove and replace the faulty bulb with the new one, of the correct type and with the same fitting; reassemble everything and check its operation, finally fixing the light!

Posted on 28 February 2025 by ScegliAuto

Video tutorial

Related tutorials

How to replace the third brake light bulb of the Audi A6
How to replace the third brake light bulb of the Audi A6
Audi A6 (2004-2012 / MK 3, C6) Today we will see the instructions that will allow us to disassemble and replace the third brake light bulbs of the Audi A6. First, we open the rear …
How to replace the rear headlight bulbs of the Audi A6
How to replace the rear headlight bulbs of the Audi A6
Audi A6 (2004-2012 / MK 3, C6) Today we will see the instructions that will allow us to disassemble and replace the rear taillight and its bulbs of the Audi A6. First, we open the …
How to Replace the Headlight Bulb on an Audi A6
How to Replace the Headlight Bulb on an Audi A6
Audi A6 (2004-2012 / MK 3, C6) To replace the headlight bulb on the Audi A6, open the hood and locate the back of the headlight assembly; to access the bulb holder, you need to rem…

Where is the Fuel Filter Located in a Volvo XC60?

In this video, you will see where the fuel filter is located in a Volvo XC60 and how to proceed if you need to replace it. As shown, the filter is positioned at the lower part of the engine, right between the left half-shaft and the sway bar attachment. To replace the filter, first, go underneath the vehicle, taking all necessary safety precautions. Then, using an 18mm wrench, open the drain valve and allow any water present to escape. Next, unscrew the housing, remove the old filter, insert the replacement along with a new gasket, and reassemble everything.

Watch the video!


by ScegliAuto

More videos