Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Installing Wheel Splash Guards

Model: Honda Cr Z MK 1 - Years: 2010, 2011, 2012, 2013, 2014, 2015, 2016
Part: Accessory kit

Video tutorial

This video shows how to install splash guards on all four wheels. To install them on the front wheels, you need to find the right position and make a hole under the side skirts, then remove the centre of the clips located in the wheel arch; position the piece and secure it with 5x25mm screws.

When installing the rear splash guards, you will need to remove the bumper to make the necessary holes; locate where to drill using factory marks and then make 5 holes for each splash guard and install 2 supports each to secure the new splash guard.

Once installed on the bumper, simply reassemble everything.


Updated on 9 February 2026 by ScegliAuto


Related tutorials

Guide to Installing Car Mudflaps
Guide to Installing Car Mudflaps
Honda Civic (2006-2012 / MK 8) The following guide shows how to install car mudflaps. The installation takes a relatively short time, about 24 minutes, and is easily achievable by …
Side Step Installation Instructions
Side Step Installation Instructions
Kia Sorento (2009-2014 / MK 2) Remove the clips along the edge of the wheel arch to take off the splash guard. Next, remove the side skirt (screws and clips) and also take out the …
How to Adjust Wheel Camber
(Various brands) Various Wheel camber represents the tilt of the tyre itself, or more technically, it is the measure of the angle between the vertical and the centre plane of…

How to unlock the radio of the Iveco Daily

When an Iveco Daily displays the radio error message or prompts to enter the radio code, it means you need to enter the unlock code to resume using the radio. This situation occurs after replacing or disconnecting the vehicle's battery. Enter the unlock code, which can be found in the vehicle's user manual or calculated through the "radio code" website. Input the code using the numeric buttons and then confirm by pressing the OK button. Once this is done, turn off and then turn on the ignition.

Watch the video!


by ScegliAuto

More videos