Do it yourself
Frequently asked questions about cars and motorcycles
In this guide, we will see the instructions on how to disassemble and replace the piston and the entire cylinder assembly of the TM Racing 125. First, unscrew the head bolts, disconnecting the spark plug and the coil connector first; disconnect the coolant pipe from the radiator. At this point, slide off the cylinder, giving you access to the piston; remove the circlip to extract the pin from the conrod, replacing the piston (or just replacing the rings). Reassemble the cylinder assembly correctly, ensuring all components are lubricated.

Posted on 29 April 2026 by ScegliAuto

Video tutorial

Related tutorials

Tm Racing 125 To remove the piston of a TM Racing 125, first remove the seat and the side panels. Next, you will need to remove the bolts securing the exhaust and …
Tm Racing 125 To replace the piston on the TM Racing 125, loosen the screws that secure the side fairings of the bike to access the underlying components. Here, yo…
Tm Racing 125 In order to replace the piston of the TM Racing 125, you will need to loosen the screws that secure the engine block to its housing, which is located…

How to Service the Beta RR 350

This video will illustrate the steps to perform the routine maintenance service, replacing the engine oil and oil filter on the Beta RR 350 enduro bike. First, place the bike on a stand and start by loosening the oil drain bolt located under the engine, allowing it to drain into a container for about ten minutes; then clean the small oil filter (replacing it with a new one if too dirty). Finally, top up with new oil, of the correct type for your engine, filling to the maximum level!

Watch the video!


by ScegliAuto

More videos