Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions
Here are the steps and guide necessary to remove and replace the rear brake pads on the Yamaha Tmax 530 scooter. First, place the scooter on its stand and start unscrewing the fixing screws of the rear brake caliper to remove it from the disc. Then, remove the old brake pads by pressing the caliper piston to retract it. At this point, clean the caliper of any residual dirt and install the new high-quality brake pads, following the video tutorial to the end!

Updated on 28 June 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Replace the Front Brake Pads of the Yamaha Tmax 530
How to Replace the Front Brake Pads of the Yamaha Tmax 530
Tmax 530 This guide provides instructions on how to remove and replace the front brake pads of the Yamaha Tmax 530. First, place your motorcycle on the centre…
How to replace the rear brake pad on the Yamaha TMAX 530 scooter?
How to replace the rear brake pad on the Yamaha TMAX 530 scooter?
Tmax 530 In this tutorial we can see how to replace the rear brake pad on the Yamaha TMAX 530 scooter, an extremely simple and quick operation. First of all, …
How to reset the Service light on the Yamaha Tmax 530?
How to reset the Service light on the Yamaha Tmax 530?
Tmax 530 To reset the Service light on the Yamaha Tmax 530, turn on the ignition by turning the key in the ignition switch: once the dashboard is lit, navigat…

Changing the Oil and Filter on the Kawasaki Versys

Here’s how to change the oil and filter on the Kawasaki Versys. Warm up the engine for a few minutes, place the motorcycle on the centre stand, open the filler cap, and remove the drain plug underneath the engine. Place a catch basin under the oil sump, unscrew the drain plug, and let the oil drain out. Unscrew the oil filter and let all the old oil drain out. Install a new filter and tighten it with the appropriate tool. Pour half a glass of new oil into the filler cap and wait for it to flow out of the drain hole, after which replace the plug. Fill with approximately 1.8 litres of new oil, take it for a short ride to circulate the oil in the engine, stop the engine, and check the level through the designated window. Top up if necessary.

Watch the video!


by ScegliAuto

More videos