Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Motorcycles
    2. :
  2. Gilera
    3. : Nordwest : Fork disassembly and maintenance on Gilera Nordwest

Model: Gilera Nordwest
Part:
Fork disassembly and maintenance on Gilera Nordwest

Unscrew all the small bolts securing the front fender, using an Allen key. Unscrew the two bolts securing the brake caliper and remove it. Then unscrew the central pin of the wheel and remove the same. Now release the fork at the top and remove it. At this point you can replace them obviously proceeding backwards for reassembly, or fix them from any fault, or even do a simple maintenance as shown in the video. Proceed backwards not only to assemble the fork but also the wheel and brake caliper.


Posted on 3 February 2024 by ScegliAuto



Fork disassembly and maintenance on Gilera Nordwest
Nordwest Unscrew all the small bolts securing the front fender, using an Allen key. Unscrew the two bolts securing the brake caliper and remove it. Then unscr
How do you perform a fork review on the Gilera Runner 125?
Runner 125 In order to perform the fork revision on the Gilera Runner 125, you first need to remove the fork from its housing: to do this, you will need to loos
Disassembly of Gilera Arizona 250 Rally forks
Arizona 250 In this video tutorial we will see how to disassemble, in simple steps, the forks of a Gilera Arizona Rally 250. First we position the rear stand on

How to remove the stator of the Peugeot Speedfight 2

Today we will see, in this video tutorial, how to disassemble and replace the stator of the Peugeot Speedfight 2 scooter, following these simple steps. In this case, the disassembly operation is carried out with the engine removed from the bodywork; then, once the rotor has been removed, we can go and unscrew the fixing screws of the stator, in order to remove it from the engine casing together with the electrical wiring, as shown in the video. At this point we are going to replace the component with the new one, with the original spare part; we install the stator in the correct direction, finally adjusting the advance.

Watch the video!


by ScegliAuto

More videos