Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Peugeot
    3. :
  3. 306
    4. : How to replace a drive shaft in Peugeot 306?

Peugeot 306 - Video tutorial

Model: Peugeot 306 MK 1 - Years 1993-2002
Part: Drive shaft
Operation: How to replace a drive shaft in Peugeot 306?

In this tutorial we can see how to replace a driveshaft in the Peugeot 306, a simple operation that requires good manual skills. We start by jacking up the side where we are going to work, obviously taking the necessary safety measures, then we remove the wheel and unscrew the fixing bolt of the lower joint. If it should be blocked, we can apply some unlocking spray and let it act for a few minutes. Once removed, we rotate the entire hub outwards, grab the drive shaft and pull it out. At this point we can insert the spare part and recompose everything following the reverse procedure.


Posted on 7 December 2022 by ScegliAuto



Where are the fuses located in the Peugeot 306?
Peugeot 306 (1993-2002 / MK 1) The fuses of the Peugeot 306 are contained within the appropriate fuse boxes that are installed in the car: in this model of car, it will be possible
How to replace the key fob case of a Peugeot 306
Peugeot 306 (1993-2002 / MK 1) In case the casing of the key for your Peugeot 306 car needs to be replaced, the procedure is not complicated. First, you will need to unscrew the sm
How to remove the door panel in the Peugeot 306?
Peugeot 306 (1993-2002 / MK 1) Removing the door panel of the Peugeot 306 is an extremely simple and fast operation, let's see how to proceed in this tutorial. First of all, let's

How to reset the oil service in the Fiat Toro?

In this tutorial we can see how to reset the oil service in the Fiat Toro. Before carrying out this simple and quick operation, make sure that you have completed any required maintenance work. We start by inserting the key but leaving it in the initial position, after which we keep the accelerator pedal fully depressed and at the same time turn on the instrument panel. At this point, always keeping the accelerator pressed, press the brake pedal 5 consecutive times and, with the pedals in position, turn off the ignition. We check that the procedure has been successful by starting the vehicle.

Watch the video!


by ScegliAuto

More videos