Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions
In order to replace the engine oil of the Aprilia RSV4 R 1000, you will need to loosen the drain plug located in the central lower part of the vehicle: once this has been removed, you will be able to drain all the old oil into a properly positioned container. Then, you will also need to remove the oil filter located in the same position in order to insert the new replacement part: after installation, you can top up the oil. You will need to pour the necessary amount of oil from the vent located on the right side.

Posted on 19 March 2025 by ScegliAuto

Video tutorial

Related tutorials

How to Change the Engine Oil and Oil Filter on an Aprilia RSV4 1100
How to Change the Engine Oil and Oil Filter on an Aprilia RSV4 1100
Rsv4 1100 This guide will show you the procedure for changing the engine oil and oil filter while performing the routine maintenance service on the Aprilia RSV…
How do you replace the levers of the Aprilia RSV4 1100?
How do you replace the levers of the Aprilia RSV4 1100?
Rsv4 1100 In order to replace the levers of the Aprilia RSV4 1100, you need to loosen the screws that secure these components to their housing, which are locat…
How do you replace the exhaust of the Aprilia RSV4 1100?
How do you replace the exhaust of the Aprilia RSV4 1100?
Rsv4 1100 It will be possible to replace the exhaust of the Aprilia RSV4 1100 by loosening the screws that fix it to its housing on the right side of the motor…

How to Turn Off the "V-Belt" Warning Light on a Yamaha X-MAX 400 Scooter?

In this tutorial, learn how to turn off the "V-Belt" warning light on the Yamaha X-MAX scooter's instrument panel, a very simple and quick operation. Before doing this, ensure you have completed the required maintenance, specifically replacing the drive belt. Start by inserting the key and turning on the ignition, then open the small right glove compartment and unscrew the screw for the upper cover. Once removed, locate the white connector with a jumper attached, disconnect it, wait about 10 seconds, and reconnect it. If successful, the warning light will disappear.

Watch the video!


by ScegliAuto

More videos