Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions

Model: Gasgas Ec 300
Part: Checks and maintenance

To replace the water pump gasket on the GasGas EC 300, you need to loosen the screws that secure the water pump protection cover, located on the right side of the bike. Once the screws are removed, you can completely remove the cover and then remove the underlying gasket. At this point, you can place the new gasket inside the cover and secure it properly. Then, you need to reposition the cover in its housing and secure it with its appropriate screws.


Posted on 22 June 2023 by ScegliAuto

This video is currently unavailable


How to install the cooling radiator on the Gasgas EC 300
Ec 300 Below we will see the instructions that will allow us to install the cooling radiator on the Gasgas EC 300 enduro motorcycle. The motorcycle is alrea
How to remove the clutch cover on Gasgas EC 300
Ec 300 Let's see in this video how to remove the cover or the clutch side crankcase on the Gasgas EC 300 enduro bike, in simple steps. First of all we go to
Assembling the starter motor on Gasgas EC 250-300
Ec 300 In today's video tutorial we will see how to install the starter motor on a Gasgas EC 250 and 300, following the instructions below. First of all, gr

How to change the motor oil of a KTM Duke 390?

To change the motor oil on a KTM Duke 390, start by placing the motorcycle on a stable stand to ensure it is in a vertical position. Under the engine, locate the oil drain plug and remove it with the appropriate wrench, allowing the used oil to completely drain into a suitable container. Once the oil has completely drained, screw the drain plug back on and tighten it properly. Next, locate the oil fill opening on the engine and fill it with the recommended new oil, using a funnel to prevent spills. Check the oil level to make sure it is correct, adding more oil if necessary. After completing the filling, start the engine and let it run for a few minutes to distribute the new oil. Finally, turn off the engine and check the oil level again, adding more if needed.

Watch the video!


by ScegliAuto

More videos