Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Install the Cooling Radiator on a Gasgas EC 300

Model: Gasgas Ec 300
Part: Radiator

Video tutorial

Below are the instructions that will allow you to install the cooling radiator on the Gasgas EC 300 enduro bike. The bike is already prepared for the radiator installation, which we will connect to the water pump; so secure the radiator to the frame and connect the various hoses as shown in the video.

At this point, top up with new coolant suitable for your radiator; then start the engine and allow the new antifreeze to circulate, checking the correct operation of the cooling system.


Updated on 30 September 2026 by ScegliAuto


Related tutorials

How to Install the Lower Engine Guard on the Gasgas EC 300
How to Install the Lower Engine Guard on the Gasgas EC 300
Ec 300 These brief and simple steps will guide you on how to install the lower engine guard on the Gasgas EC 300 enduro bike. First, place the bike on a sta…
How to remove and replace the carburettor on a Gasgas EC 300?
How to remove and replace the carburettor on a Gasgas EC 300?
Ec 300 Today, you will learn how to remove and replace the carburettor on a Gasgas EC 300 enduro bike by following these simple steps. First, place your bik…
How to replace the front brake pads on the Gasgas EC 300
How to replace the front brake pads on the Gasgas EC 300
Ec 300 This guide outlines the steps to remove and replace the front brake pads on the Gasgas EC 300 enduro motorcycle. First, place the motorcycle on a sta…

How to Replace the Headlight Bulb on the Suzuki Address 110

To replace the headlight bulb on the Suzuki Address 110, you must completely remove the wing mirrors so that you can rotate them counterclockwise: once removed, proceed to loosen the screws securing the front fairing, located at the sides of the instrument cluster. Once the front fairing is removed, disconnect the internal connector of the headlight, allowing the bulb inside to be extracted and replaced with a new one; after replacement, reassemble all the removed parts.

Watch the video!


by ScegliAuto

More videos