Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to replace the front brake pads on the Gasgas EC 300

Model: Gasgas Ec 300
Part: Brake pads

Video tutorial

This guide outlines the steps to remove and replace the front brake pads on the Gasgas EC 300 enduro motorcycle. First, place the motorcycle on a stand and begin unscrewing the fixing screws of the front brake caliper, then remove it from the disc; press the caliper piston to remove the old brake pads.

Next, clean the caliper from any residual dirt and install the new original brake pads; then refit the brake caliper onto the disc, adjusting the front brake if necessary.


Posted on 29 April 2026 by ScegliAuto


Related tutorials

How do you replace the rear brake disc of the GasGas EC 300?
How do you replace the rear brake disc of the GasGas EC 300?
Ec 300 In order to replace the rear brake disc of the GasGas EC 300, you need to loosen the nuts that secure the rear wheel of the motorcycle to its housing…
How to Replace the Front Brake Fluid on the Gasgas EC 300
How to Replace the Front Brake Fluid on the Gasgas EC 300
Ec 300 This guide explains how to bleed and replace the front brake fluid on the Gasgas EC 300 enduro bike. First, remove the screws from the brake fluid re…
Installing Starter Motor on Gasgas EC 250-300
Installing Starter Motor on Gasgas EC 250-300
Ec 300 In today's tutorial video, you will see how to install the starter motor on a Gasgas EC 250 and 300, following the instructions below. First, grease …

How to Change the Engine Oil of a Yamaha XT 250?

The Yamaha XT 250 is a motorcycle and, like all motorcycles, it does not use a flywheel or buttons for operations like changing the engine oil. Here’s the correct procedure: To change the engine oil of a Yamaha XT 250, ensure the bike is stable on a stand and that the engine is warm to facilitate oil drainage. Locate the oil drain plug under the engine and position a container to collect the used oil. Use a spanner to unscrew the drain plug and let the old oil drain completely. Remove the oil filter located on the side of the engine. Replace it with a new one, ensuring to lightly lubricate the seal with fresh oil before installing it. After installing the new filter, re-tighten the drain plug, being careful to avoid leaks. Find the oil filler cap on the top side of the engine and pour in the specified amount of new oil according to the XT 250 manual. Once filled, start the engine for a few minutes and check for leaks. Turn off the bike, let it rest for a moment, and check the oil level using the dipstick or indicator, adding more oil if necessary. This procedure ensures optimal lubrication for your Yamaha XT 250.

Watch the video!


by ScegliAuto

More videos