Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions
In order to replace the engine oil of the Kymco Spade 150, you need to loosen the drain plug of the oil pan, which is located in the central lower part of the motorcycle, on the left side of it: once the oil has completely drained out, you can close the drain plug again, so that you can top up the oil. To do this, you will need to remove the plug located on the top of the crankcase on the right side of the motorcycle: once the necessary amount of oil has been added, you can close the crankcase and make sure everything is functioning properly.

Posted on 1 January 2025 by ScegliAuto

Video tutorial

Related tutorials

How to Change the Engine Oil on a Kymco Spade 150
Spade 150 To change the engine oil on the Kymco Spade 150, loosen the drain plug located at the central lower part of the bike: once the plug is unscrewed, the…
How to Replace the Seat of the Kymco Spade 150?
How to Replace the Seat of the Kymco Spade 150?
Spade 150 To replace the seat of the Kymco Spade 150, loosen all the corresponding screws that secure the seat to its housing: there are four fixing screws loc…
How to Reset the Service on a Kymco Spade 150 Scooter
How to Reset the Service on a Kymco Spade 150 Scooter
Spade 150 In this tutorial, learn how to reset the service on a Kymco Spade 150 scooter, a very simple and quick operation. Before proceeding, ensure that all …

How to Check the Coolant Level in a Yamaha Xmax

In the following video, you will learn how to check the coolant level in a 2008 Yamaha Xmax. First, position the motorcycle on a stable surface by raising the stand. Next, lift the cover located at the top of the motorcycle to access the coolant drain bolt. To top up the coolant, unscrew the cap as shown in the video and add the fluid until it reaches the maximum level, indicated as Max. Once finished, close the valve and refit the cover. At this point, start the engine and let it run at idle for a few minutes to eliminate any air bubbles that may have formed inside.

Watch the video!


by ScegliAuto

More videos