Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions
To replace the levers of the Harley Davidson Sportster, you need to loosen the screws that hold them to their respective housing on the sides of the handlebars: once the screws have been removed and the corresponding nuts have been taken off, you can disconnect the cables connected to the levers. Once the levers have been completely freed, you can then connect the new ones to the cables: this way you can attach them to their side housing on the handlebars to ensure that everything works properly.

Posted on 27 July 2025 by ScegliAuto

Video tutorial

Related tutorials

How to Replace the Battery on the Harley Davidson Sportster S?
How to Replace the Battery on the Harley Davidson Sportster S?
Sportster S You can replace the battery on the Harley Davidson Sportster S by loosening the screws that secure the protection plate at the lower front of the veh…
How to Replace the Remote Battery for the Harley-Davidson Sportster S?
How to Replace the Remote Battery for the Harley-Davidson Sportster S?
Sportster S In this tutorial, see how to replace the remote battery for the Harley-Davidson Sportster S, an extremely simple and quick operation. For this, you w…
How to replace the battery on a Harley Davidson Sportster S?
How to replace the battery on a Harley Davidson Sportster S?
Sportster S You can replace the installed battery on the Harley Davidson Sportster S by loosening the screws that secure the cover panel located immediately behi…

How to Check the Coolant Level in a Yamaha Xmax

In the following video, you will learn how to check the coolant level in a 2008 Yamaha Xmax. First, position the motorcycle on a stable surface by raising the stand. Next, lift the cover located at the top of the motorcycle to access the coolant drain bolt. To top up the coolant, unscrew the cap as shown in the video and add the fluid until it reaches the maximum level, indicated as Max. Once finished, close the valve and refit the cover. At this point, start the engine and let it run at idle for a few minutes to eliminate any air bubbles that may have formed inside.

Watch the video!


by ScegliAuto

More videos