Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Model: Honda Sh 300
Part:

In this video we see how to disassemble and then reassemble the saddle of the Honda SH300: disassembling it is really very simple, because at the point where the saddle pivots and lifts, there is a hinge where there are only 10 mm bolts, which need to be unscrewed to allow the entire saddle to come off. Second-hand saddles for this scooter are easily found online, and cost between 50/60 euros: just type "used saddle for SH300" and a world will open up. Just be very careful about the year of construction, you need to find one that is perfectly compatible. Reassembly is just as simple: the usual two 10mm bolts are placed back in the hinge and in the new saddle and the job is done.

Posted on 27 October 2025 by ScegliAuto

Video tutorial

Related tutorials

How to Replace the Battery of the Honda SH 300
How to Replace the Battery of the Honda SH 300
Sh 300 If you are experiencing serious issues with the battery of your Honda SH 300, you will need to replace the entire component. Just follow these instru…
How to Replace the Battery on Honda SH 300
How to Replace the Battery on Honda SH 300
Sh 300 To replace the battery on the Honda SH 300, first lift the seat and unscrew the two screws located at the front of the seat, near the hinge, to remov…
How to Reset the "Service" Light on a Honda SH 300
How to Reset the "Service" Light on a Honda SH 300
Sh 300 Before you can start, ensure that the engine oil change has been carried out, and then sit on the seat of your Honda SH 300. Begin by activating the …

How to Turn Off the "V-Belt" Warning Light on a Yamaha X-MAX 400 Scooter?

In this tutorial, learn how to turn off the "V-Belt" warning light on the Yamaha X-MAX scooter's instrument panel, a very simple and quick operation. Before doing this, ensure you have completed the required maintenance, specifically replacing the drive belt. Start by inserting the key and turning on the ignition, then open the small right glove compartment and unscrew the screw for the upper cover. Once removed, locate the white connector with a jumper attached, disconnect it, wait about 10 seconds, and reconnect it. If successful, the warning light will disappear.

Watch the video!


by ScegliAuto

More videos