Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Set the Time on a Kymco DTX360?

Model: Kymco Dtx 360
Part: Clock

Video tutorial

To set the time on a Kymco DTX360, follow these steps. First, turn on the scooter and ensure it is in time display mode on the dashboard.

Once you find this mode, press and hold the button for setting the time, located on the scooter's handlebars. After a few seconds, the display will start to flash, indicating that you can now adjust the time.

Use the adjustment buttons to increase or decrease the hour until you reach the desired time. When you have set the correct time, press the time setting button again to confirm your selection.

The display will stop flashing and the time will be set correctly. Be sure to consult the owner's manual for specific instructions for your Kymco DTX360 model, as the procedure may vary slightly.


Updated on 8 November 2026 by ScegliAuto


Related tutorials

How to replace the battery of the Kymco DTX 360?
How to replace the battery of the Kymco DTX 360?
Dtx 360 To replace the battery of the Kymco DTX 360, loosen the screws securing the front fairing of the bike, removing both the specific panel and the corre…
How to Remove the Fairing of the Kymco DTX 360
How to Remove the Fairing of the Kymco DTX 360
Dtx 360 Today, we will explain how to remove the fairing of the Kymco DTX 306. To perform this operation, remove the front cover of the scooter. Unscrew the …
How to Change the Oil on the Kymco DT X360
How to Change the Oil on the Kymco DT X360
Dtx 360 Let's see how to change the oil on the Kymco TDX360: you will need a 12mm spanner, a syringe to inject the fluid, and a container to drain the used o…

How to Replace the USB Socket on the Benelli TRK 502?

To replace the USB socket on the Benelli TRK 502, loosen the screws securing the left side panel of the motorcycle, located just below the handlebars: once this panel is freed, you can remove it and locate the USB socket connector. By disconnecting this connector, you can pull the socket out of its housing: then connect the new socket to the connector, inserting it into its housing. After installation, check that the socket works by reinstalling the panel.

Watch the video!


by ScegliAuto

More videos