Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Remove the Fairing of the Kymco DTX 360

Model: Kymco Dtx 360
Part: Checks and maintenance

Video tutorial

Today, we will explain how to remove the fairing of the Kymco DTX 306. To perform this operation, remove the front cover of the scooter. Unscrew the screws located inside the central headlight cover and carefully unscrew the screws along the sides of the scooter.

Disconnect the power connectors to remove the central part by pulling it outward. The installation of the fairing follows the reverse procedure; connect the connector to the fairing and screw in the screws positioned along the central cover and the headlight.

Insert the bulb and ensure that the screws are tight before hitting the road.


Posted on 30 March 2026 by ScegliAuto


Related tutorials

How to replace the battery of the Kymco DTX 360?
How to replace the battery of the Kymco DTX 360?
Dtx 360 To replace the battery of the Kymco DTX 360, loosen the screws securing the front fairing of the bike, removing both the specific panel and the corre…
How do you change the engine oil of the Kymco DTX 360?
How do you change the engine oil of the Kymco DTX 360?
Dtx 360 The procedure for replacing the motor oil on the Kymco DTX 360 can be carried out by loosening the drain plug of the oil pan, which will be located o…
How do you adjust the time on the Kymco Dtx 360?
How do you adjust the time on the Kymco Dtx 360?
Dtx 360 The screen displayed in the video belongs to the Kymco Dtx 360 and if we pay attention, we will notice the time on the left side, information that we…

How to Change the Engine Oil of a BMW R9T

To change the engine oil of a BMW R9T, follow these steps. Ensure the engine is warm but not too hot. Position the bike on a flat surface and lift the front using a motorcycle stand. Remove the oil cap from the engine oil reservoir. Place a catch container under the oil drain plug, usually located on the underside of the engine. Unscrew the oil drain plug and let the old oil drain completely into the container. Once drained, re-tighten the oil drain plug. Remove the oil filter using an oil filter wrench. Clean the mounting surface of the filter and apply a bit of new oil to the seal of the new filter. Install the new oil filter. At this point, fill the engine with new oil, and you will have completed the replacement.

Watch the video!


by ScegliAuto

More videos