Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How do you change the engine oil of the Kymco DTX 360?

Model: Kymco Dtx 360
Part: Engine oil

Video tutorial

The procedure for replacing the motor oil on the Kymco DTX 360 can be carried out by loosening the drain plug of the oil pan, which will be located on the left side of the vehicle, in correspondence with the rear wheel. Once this plug has been unscrewed, it will be possible to collect the used oil inside a container to be properly positioned.

Once the oil has completely drained out, it will be possible to close the drain plug and top up the oil: this must be done through the vent located on the opposite side, again in correspondence with the rear wheel of the motorcycle.


Posted on 5 June 2025 by ScegliAuto


Related tutorials

How to replace the battery of the Kymco DTX 360?
How to replace the battery of the Kymco DTX 360?
Dtx 360 To replace the battery of the Kymco DTX 360, loosen the screws securing the front fairing of the bike, removing both the specific panel and the corre…
How do you adjust the time on the Kymco Dtx 360?
How do you adjust the time on the Kymco Dtx 360?
Dtx 360 The screen displayed in the video belongs to the Kymco Dtx 360 and if we pay attention, we will notice the time on the left side, information that we…
How to Remove the Fairing of the Kymco DTX 360
How to Remove the Fairing of the Kymco DTX 360
Dtx 360 Today, we will explain how to remove the fairing of the Kymco DTX 306. To perform this operation, remove the front cover of the scooter. Unscrew the …

How to Change the Engine Oil of a BMW R9T

To change the engine oil of a BMW R9T, follow these steps. Ensure the engine is warm but not too hot. Position the bike on a flat surface and lift the front using a motorcycle stand. Remove the oil cap from the engine oil reservoir. Place a catch container under the oil drain plug, usually located on the underside of the engine. Unscrew the oil drain plug and let the old oil drain completely into the container. Once drained, re-tighten the oil drain plug. Remove the oil filter using an oil filter wrench. Clean the mounting surface of the filter and apply a bit of new oil to the seal of the new filter. Install the new oil filter. At this point, fill the engine with new oil, and you will have completed the replacement.

Watch the video!


by ScegliAuto

More videos