|
Do it yourself
| |||
| ||||
Model: Honda Crf 450
To replace the rear brake pads on a Honda CRF 450, it is not necessary to completely disassemble the brake caliper from the disc. Simply remove the lateral fastening elements that secure the pin inserted within the pads. Once the fastening elements are removed, you can slide out the pin, and then, using a lever, remove the pads from inside the caliper. This will allow you to insert the new pads into the caliper, securing them with the appropriate pin.
Updated on 13 June 2026 by ScegliAuto
Video tutorial
Related tutorials
Crf 450
To replace the clutch on the Honda CRF 450, loosen the bolts securing the cover on the right side of the bike so that it can be removed. Once the cov…
Crf 450
To replace the exhaust on the Honda CRF 450, loosen the screws that secure the side panel at the rear of the bike. Once this panel is removed, you wi…
Crf 450
To replace the clutch on the Honda CRF 450R, loosen the bolts securing the circular cover on the right side of the bike. Once these bolts are loosene…
|
How to Service the Beta RR 350
This video will illustrate the steps to perform the routine maintenance service, replacing the engine oil and oil filter on the Beta RR 350 enduro bike. First, place the bike on a stand and start by loosening the oil drain bolt located under the engine, allowing it to drain into a container for about ten minutes; then clean the small oil filter (replacing it with a new one if too dirty). Finally, top up with new oil, of the correct type for your engine, filling to the maximum level! by ScegliAuto More videos
|
|
For advertising on this site Write to info@scegliauto.com
ScegliAuto is not responsible for any inaccuracy of the data in the lists. To report any inaccuracy or your business (if you own the business in question), please write to info@scegliauto.com
Number of seconds to generate the page: 0.007
(c) ScegliAuto 2026 - info@scegliauto.com - Privacy policy VAT number: IT01247470535 |
