Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Model: Honda Sh 300
Part: Spark plugs

In today's video, we will see how to replace the spark plugs in the Honda SH 300. Always proceed with the engine cold. Remove the maintenance cover and the two screws. Then, take off the battery compartment cover and place it on the ground. You can now locate the spark plug cap in front of you. It is advisable to remove the screws from the left passenger footpeg to create more working space. Also, remove the other screws present inside, and then proceed to remove the old spark plugs with the appropriate tool. Follow the same steps in reverse for reassembly.

Updated on 26 July 2026 by ScegliAuto

Video tutorial

Related tutorials

Where is the battery located on a Honda SH 300?
Where is the battery located on a Honda SH 300?
Sh 300 The battery of your Honda SH 300 powers the scooter's electrical system, including the starter motor when you need to start the engine. The battery i…
How to Replace the Transmission Oil on a Honda SH 300
How to Replace the Transmission Oil on a Honda SH 300
Sh 300 Here are the steps to replace the transmission oil on the Honda SH 300 scooter, following the instructions below. First, place the scooter on the cen…
How to Replace the Windscreen on a Honda SH 300?
Sh 300 To replace the windscreen on a Honda SH 300, you need to loosen the screws that secure the front fairing of the bike, allowing it to be completely re…

How to Turn Off the "V-Belt" Warning Light on a Yamaha X-MAX 400 Scooter?

In this tutorial, learn how to turn off the "V-Belt" warning light on the Yamaha X-MAX scooter's instrument panel, a very simple and quick operation. Before doing this, ensure you have completed the required maintenance, specifically replacing the drive belt. Start by inserting the key and turning on the ignition, then open the small right glove compartment and unscrew the screw for the upper cover. Once removed, locate the white connector with a jumper attached, disconnect it, wait about 10 seconds, and reconnect it. If successful, the warning light will disappear.

Watch the video!


by ScegliAuto

More videos