Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Model: Honda Cbr 300r
Part: Clock

To manually change the time displayed on the dashboard of your 2021 Honda CBR300R, simply follow these steps. First, position the bike on its stand and start the dashboard. Then, press and hold the two buttons located below the display and release them as soon as the time displayed starts to flash. At this point, use the "Reset" button to change the hour digit. Then press "Mode" to switch to minutes and repeat the same operation. Finally, wait for the display to stop flashing, and you are done.

Updated on 14 September 2026 by ScegliAuto

Video tutorial

Related tutorials

How to adjust the clock on the Honda CBR 300 R?
How to adjust the clock on the Honda CBR 300 R?
Cbr 300r In this tutorial we can see how to adjust the time on the Honda CBR 300 R, an extremely simple and quick operation, to be carried out for example aft…
How to Change the Engine Oil in the Honda CBR 300?
How to Change the Engine Oil in the Honda CBR 300?
Cbr 300r As shown in this tutorial, changing the engine oil in the Honda CBR 300 is a straightforward and quick task. First, ensure the engine is cool enough …
How to Replace the Headlight Bulb of the Honda CBR 300R
How to Replace the Headlight Bulb of the Honda CBR 300R
Cbr 300r To replace the headlight bulb of the Honda CBR 300R, access the area between the fork and the front fairing, where the internal protective cover of t…

How to Turn Off the "V-Belt" Warning Light on a Yamaha X-MAX 400 Scooter?

In this tutorial, learn how to turn off the "V-Belt" warning light on the Yamaha X-MAX scooter's instrument panel, a very simple and quick operation. Before doing this, ensure you have completed the required maintenance, specifically replacing the drive belt. Start by inserting the key and turning on the ignition, then open the small right glove compartment and unscrew the screw for the upper cover. Once removed, locate the white connector with a jumper attached, disconnect it, wait about 10 seconds, and reconnect it. If successful, the warning light will disappear.

Watch the video!


by ScegliAuto

More videos