Do it yourself
Frequently asked questions about cars and motorcycles
To replace the starter motor of the Husaberg TE 300, you need to loosen the screws that hold the side panel of the engine cover so that you can access the flywheel: once this part is located, you will be able to find the starter motor next to the flywheel and loosen the screws that hold it in place in order to remove it. You will also need to disconnect the appropriate connector, to which the new piece will be connected: this can now be covered by the corresponding panel, making sure that everything works correctly.

Posted on 27 September 2025 by ScegliAuto

Video tutorial

Related tutorials

Te 300 In order to replace the rear shock absorber of the Husaberg TE 300, you need to loosen the screws that secure the fender panels so that it can be rem…
Te 300 To complete the replacement of the fairing of the Husaberg TE 300, you will need to loosen the screws that secure all the panels that make it up: you…
Te 300 To replace the exhaust on the Husaberg TE 300, loosen the screws securing the panel located on the rear side of the bike, near the mudguard. Once the…

How to Service the Beta RR 350

This video will illustrate the steps to perform the routine maintenance service, replacing the engine oil and oil filter on the Beta RR 350 enduro bike. First, place the bike on a stand and start by loosening the oil drain bolt located under the engine, allowing it to drain into a container for about ten minutes; then clean the small oil filter (replacing it with a new one if too dirty). Finally, top up with new oil, of the correct type for your engine, filling to the maximum level!

Watch the video!


by ScegliAuto

More videos