Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Hyundai
    3. :
  3. I40
    4. : Checks and maintenance

Hyundai I40 - Checks and maintenance

Checks And Maintenance Hyundai I40 (2011-2019 / mk 1)

Hyundai I40 (2011-2019 / MK 1)
How to Disable ECO Mode in a Hyundai i40?
In this tutorial, you will see how to disable ECO mode in a Hyundai i40, a very simple and quick operation, for example, if you find it too intrusive. First, …Read all…
Posted on 14 September 2026 by ScegliAuto
Hyundai I40 (2011-2019 / MK 1)
Where is the OBD port of the Hyundai I40 located?
If you are planning to use the OBD port of your Hyundai I40 but do not know where it is located, do not worry because in the following guide you will find the …Read all…
Posted on 2 November 2025 by ScegliAuto
Hyundai I40 (2011-2019 / MK 1)
Reset of the partial mileage counter of the Hyundai I40
Today's steps will illustrate how to reset the partial mileage counter of the Hyundai I40, following the instructions below. First, we get on board the car and …Read all…
Posted on 21 April 2025 by ScegliAuto
Airbag (1) Car stereo (2) Key (5) Timing belt (1) Onboard computer (6) Checks and maintenance (3) Headlight (1) Air filter (1) Cabin air filter (2) Tail light bulb (1) Clock (1) Front bumper (1) Shift knob (1) Car door (1) Heater core (1) Fuse box (3) (2) Tire pressure warning light (1) Service warning light (16) Steering wheel (1)

How to Connect the Cables to the Battery of the Citroen Xsara Picasso?

In this tutorial, you will see how to connect the cables to the battery of the Citroen Xsara Picasso, useful if you need to recharge it or perform an emergency start. First, ensure the key is not inserted, then open the bonnet and move to the front of the left headlamp. Next, locate the bolt just behind the filter box and connect the positive terminal clamp to it. Now you can connect the negative terminal to any point on the chassis, such as the indicated point. Once the operation is complete, ensure you disconnect the negative first and then the positive.

Watch the video!


by ScegliAuto

More videos