Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Build a Chipboard Panel for the Boot of the Jeep Cherokee

Model: Jeep Cherokee XJ, MK 2 - Years 1984-2001

In this guide, you will learn how to build a panel for the bottom of the boot of the Jeep Cherokee. First, open the boot door and cut 4 pieces of cardboard to fit in the respective corners of your boot. Remember to label them with their positions. Now, using a tape measure, take the measurements for both length and width of your boot. Next, transfer both the cardboard pieces and their corresponding measurements onto your chipboard. After marking the shape of the boot floor on the chipboard with a marker, you can cut it using a circular saw or jigsaw. Now, test your new boot floor in the boot and refine it if necessary. To secure the new floor, simply use double-sided tape, which will not cause issues if you wish to remove it and revert to the original floor.

Updated on 1 June 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Remove the Tailgate Panel of the Jeep Cherokee
How to Remove the Tailgate Panel of the Jeep Cherokee
Jeep Cherokee (2013-2023 / KL, MK 5) In this video tutorial, you will learn how to remove and replace the tailgate panel of the Jeep Cherokee, allowing access to the camera and tailgate …
…
How to Remove the Door Panel and Handle of the Jeep Cherokee
How to Remove the Door Panel and Handle of the Jeep Cherokee
Jeep Cherokee (2013-2023 / KL, MK 5) These brief steps will show you how to remove and replace the door panel and handle of the Jeep Cherokee. First, open the front door and begin to dis…

Where is the Fuel Filter Located in a Volvo XC60?

In this video, you will see where the fuel filter is located in a Volvo XC60 and how to proceed if you need to replace it. As shown, the filter is positioned at the lower part of the engine, right between the left half-shaft and the sway bar attachment. To replace the filter, first, go underneath the vehicle, taking all necessary safety precautions. Then, using an 18mm wrench, open the drain valve and allow any water present to escape. Next, unscrew the housing, remove the old filter, insert the replacement along with a new gasket, and reassemble everything.

Watch the video!


by ScegliAuto

More videos