Do it yourself
Frequently asked questions about cars and motorcycles
In this tutorial, you will see how to remove the starter motor on a Kawasaki Ninja 250, a very simple and quick operation. Before proceeding, ensure that the key is not inserted for safety. Start by removing both side fairings, then position yourself on the right side, locate the starter motor, and using a 10mm spanner, undo the two securing bolts. Next, separate the unit from the engine using leverage, disconnect the power connector, and install the replacement by following the reverse procedure.

Updated on 27 August 2026 by ScegliAuto

Video tutorial

Related tutorials

Ninja 250 Good morning, today you will replace the spark plug on your Kawasaki Ninja 250. Start by removing the side fairings of the bike. Next, disconnect the…
Ninja 250 Today, you will learn how to remove and replace the spark plugs on a Kawasaki Ninja 250. After removing the seat and the fuel tank by unscrewing all …
Ninja 250 As we can see in this tutorial, removing the seat on the Kawasaki Ninja 250 is an extremely simple and quick operation. First, unscrew the two screws…

How to Service the Beta RR 350

This video will illustrate the steps to perform the routine maintenance service, replacing the engine oil and oil filter on the Beta RR 350 enduro bike. First, place the bike on a stand and start by loosening the oil drain bolt located under the engine, allowing it to drain into a container for about ten minutes; then clean the small oil filter (replacing it with a new one if too dirty). Finally, top up with new oil, of the correct type for your engine, filling to the maximum level!

Watch the video!


by ScegliAuto

More videos