Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Model: Kymco Like 150i
Part: Battery

Lift the seat using the ignition key to access the compartment underneath. At the back of the compartment, you will notice a small cover that you need to remove: to do this, simply unscrew the two side fixing screws. Once you have removed the plastic cover, you will see the battery: unscrew the two upper screws holding it in place with another plastic cover, and finally, pull out the battery. While doing this, you must disconnect the two terminals, unscrewing the negative terminal first and then the positive terminal. Proceed in reverse for reassembly.

Updated on 3 April 2026 by ScegliAuto

Video tutorial

Related tutorials

How to replace the battery of the Kymco Like 150i
How to replace the battery of the Kymco Like 150i
Like 150i Following these brief steps, we will see how to disassemble and replace the battery of the Kymco Like 150i scooter. First of all, we put the scooter …
How to Replace the Battery on a Kymco Like 150i
How to Replace the Battery on a Kymco Like 150i
Like 150i Before you begin, place your Kymco Like 150i on its centre stand. Start by opening the under-seat compartment of the scooter, then remove the under-s…
How to Replace the Air Filter on a Kymco Like 150i
How to Replace the Air Filter on a Kymco Like 150i
Like 150i Before you begin, position your Kymco Like 150i on its centre stand. Start by removing the seat and under-seat panel by unscrewing the fixing bolts. …

How to Check the Coolant Level in a Yamaha Xmax

In the following video, you will learn how to check the coolant level in a 2008 Yamaha Xmax. First, position the motorcycle on a stable surface by raising the stand. Next, lift the cover located at the top of the motorcycle to access the coolant drain bolt. To top up the coolant, unscrew the cap as shown in the video and add the fluid until it reaches the maximum level, indicated as Max. Once finished, close the valve and refit the cover. At this point, start the engine and let it run at idle for a few minutes to eliminate any air bubbles that may have formed inside.

Watch the video!


by ScegliAuto

More videos