Do it yourself
Frequently asked questions about cars and motorcycles

How to replace the gear knob of the Mini Cooper F56

Model: Mini Mini F56, F57, F54, F55 - Years 2014-2023
Part: Shift knob

In today's article, we will explain how to replace the gear knob of the Mini Cooper F56. This procedure is useful for replacing a worn gear knob. The only tool needed for this operation is a flathead screwdriver. To replace the gear knob, first use the screwdriver to lever on the lower side of the lever as shown in the video below, apply pressure to lift it up. Once lifted, pay attention as there is a connector that needs to be disconnected. After disconnecting the connector, lift the cover of the gear lever to reach under the knob. Then, grab the gear knob and lift it forcefully to remove it. Now, remove the fixing pin of the knob from the cover in order to replace it. Then, secure the new knob with the appropriate pin, insert the knob, reattach the cover correctly, reconnect the connector, and then reinsert the block by applying pressure with your hands.

Posted on 8 December 2024 by ScegliAuto

Video tutorial

Related tutorials

Mini (2014-2023 / F56, F57, F54, F55) Today's guide will show you how to remove and replace the gear shift knob of the Mini Cooper. First, get into the vehicle and start by pulling off th…
Mini (2001-2007 / R53, R52, R50) Today's guide will provide the necessary information to remove and replace the gear knob on the Mini Cooper. First, get inside the vehicle and pull u…
Mini (2001-2007 / R53, R52, R50) This short and simple guide will show us the instructions that will allow us to disassemble and replace the gear knob of the Mini Cooper. First of al…

Where is the Fuel Filter Located in a Volvo XC60?

In this video, you will see where the fuel filter is located in a Volvo XC60 and how to proceed if you need to replace it. As shown, the filter is positioned at the lower part of the engine, right between the left half-shaft and the sway bar attachment. To replace the filter, first, go underneath the vehicle, taking all necessary safety precautions. Then, using an 18mm wrench, open the drain valve and allow any water present to escape. Next, unscrew the housing, remove the old filter, insert the replacement along with a new gasket, and reassemble everything.

Watch the video!


by ScegliAuto

More videos