Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions
It will be possible to replace the coolant of the MV Agusta Veloce 800 by disconnecting the hose for the passage of the liquid located on the right side of the motorcycle, in the central lower part of the corresponding side. Once the hose is disconnected, the liquid must be collected in a suitable container; at this point, the hose must be reconnected and the refill carried out. The necessary amount of liquid must be poured into the vent located at the handlebar: after the refill, it can be verified that everything is functioning correctly.

Posted on 3 November 2025 by ScegliAuto

Video tutorial

Related tutorials

How do you replace the motor oil of the MV Agusta Turismo Veloce 800?
How do you replace the motor oil of the MV Agusta Turismo Veloce 800?
Turismo Veloce It will be possible to replace the MV Agusta Turismo Veloce 800 by loosening the oil drain plug located in the central lower part of the vehicle: onc…
How to Install Auxiliary Lights on the MV Agusta Turismo Veloce 800
How to Install Auxiliary Lights on the MV Agusta Turismo Veloce 800
Turismo Veloce Today, we will discover the main instructions for installing auxiliary lights or fog lights on the MV Agusta Turismo Veloce 800 motorcycle. First, ob…
How to Remove and Refit the Side Bags on the MV Agusta Turismo Veloce 800
How to Remove and Refit the Side Bags on the MV Agusta Turismo Veloce 800
Turismo Veloce In this brief guide, discover how to remove and install the side travel bags on the MV Agusta Turismo Veloce 800. First, place your motorcycle on the…

How to Check the Coolant Level in a Yamaha Xmax

In the following video, you will learn how to check the coolant level in a 2008 Yamaha Xmax. First, position the motorcycle on a stable surface by raising the stand. Next, lift the cover located at the top of the motorcycle to access the coolant drain bolt. To top up the coolant, unscrew the cap as shown in the video and add the fluid until it reaches the maximum level, indicated as Max. Once finished, close the valve and refit the cover. At this point, start the engine and let it run at idle for a few minutes to eliminate any air bubbles that may have formed inside.

Watch the video!


by ScegliAuto

More videos