Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions
In this tutorial we can see how to replace the engine oil in the Suzuki GSX-R 1000, an extremely simple and quick operation. First of all, make sure that the engine is sufficiently cold, then remove both side fairings and place a container underneath the motorcycle. Next, locate the drainage hole bolt, unscrew it using a 17mm socket wrench and let all the oil in the system drain out. At this point, we can unscrew the old filter, tighten both the replacement and the bolt, and pour in the new oil through the appropriate hole.

Posted on 4 October 2024 by ScegliAuto

Video tutorial

Related tutorials

How to change the engine oil in the Suzuki GSX-R 1000?
How to change the engine oil in the Suzuki GSX-R 1000?
Gsx R 1000 .. In this tutorial, we will see how to replace the engine oil in the Suzuki GSX-R 1000, an extremely simple and quick operation. First.. …
How do you disassemble the engine of the Suzuki GSX-R 1000?
How do you disassemble the engine of the Suzuki GSX-R 1000?
Gsx R 1000 .. To replace the engine of the Suzuki GSX-R 1000, you need to loosen the screws that fix the piece to its housing located in the center of the.. …
How to change the battery of the Suzuki GSX-R 1000
How to change the battery of the Suzuki GSX-R 1000
Gsx R 1000 .. and replace the battery of the Suzuki GSX-R 1000 motorcycle. First of all, we put the motorcycle on the stand and start by removing the driver's.. …

How to Check the Coolant Level in a Yamaha Xmax

In the following video, you will learn how to check the coolant level in a 2008 Yamaha Xmax. First, position the motorcycle on a stable surface by raising the stand. Next, lift the cover located at the top of the motorcycle to access the coolant drain bolt. To top up the coolant, unscrew the cap as shown in the video and add the fluid until it reaches the maximum level, indicated as Max. Once finished, close the valve and refit the cover. At this point, start the engine and let it run at idle for a few minutes to eliminate any air bubbles that may have formed inside.

Watch the video!


by ScegliAuto

More videos