Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions
In order to replace the rear brake pads of the Suzuki Hayabusa, you will need to loosen the screws that secure the brake caliper to the corresponding disc: once the caliper has been completely released, it will be possible to proceed by disconnecting it and removing the fixing pin that holds the pads in place. At this point, it will be possible to remove the old pads in order to insert the new ones: then it will be necessary to secure them with the respective pin and reattach the caliper to the disc using the appropriate fixing screws that were previously removed.

Posted on 15 March 2025 by ScegliAuto

Video tutorial

Related tutorials

How to Replace the Rear Brake Pads on a Suzuki Hayabusa?
How to Replace the Rear Brake Pads on a Suzuki Hayabusa?
Hayabusa In this tutorial, see how to replace the rear brake pads on a Suzuki Hayabusa, an extremely simple and quick operation. First, position yourself in f…
How to Set the Time on the Suzuki Hayabusa?
How to Set the Time on the Suzuki Hayabusa?
Hayabusa In this tutorial, we will see how to set the time on the Suzuki Hayabusa, a very simple and quick operation to perform after disconnecting the batter…
How to Replace the Clutch on the Suzuki Hayabusa?
How to Replace the Clutch on the Suzuki Hayabusa?
Hayabusa To replace the clutch on the Suzuki Hayabusa, loosen the screws that secure the clutch cover located on the right side of the bike: once the screws a…

How to Turn Off the "V-Belt" Warning Light on a Yamaha X-MAX 400 Scooter?

In this tutorial, learn how to turn off the "V-Belt" warning light on the Yamaha X-MAX scooter's instrument panel, a very simple and quick operation. Before doing this, ensure you have completed the required maintenance, specifically replacing the drive belt. Start by inserting the key and turning on the ignition, then open the small right glove compartment and unscrew the screw for the upper cover. Once removed, locate the white connector with a jumper attached, disconnect it, wait about 10 seconds, and reconnect it. If successful, the warning light will disappear.

Watch the video!


by ScegliAuto

More videos