Do it yourself
Frequently asked questions about cars and motorcycles

Rear lid opening height adjustment

Model: Toyota Rav 4 Xa30, MK 3 - Years 2006-2013
Part: Bodywork

The car model presented in the video is equipped with a fully automatic electrically operated opening and closing system for the rear bonnet: it is in fact possible to open the tailgate either with the remote control or with the button in the center of the bonnet itself, immediately below. to the frieze of the manufacturer; to close it you can use the remote control or the button under the edge of the bonnet, to the left of the lock. If you have particular height requirements, such as a mezzanine in the garage, you can adjust the opening height of the hood: set the opening height by keeping the tailgate in position and hold down the closing button for about five seconds.


Posted on 27 August 2023 by ScegliAuto



How to adjust the opening of the rear door of the Toyota RAV 4
Toyota Rav 4 (2019-2024 / Xa50, MK 5) Let's go and see in this short and simple guide the steps that will allow us to adjust the opening of the rear hatch of the Toyota RAV 4. First of al
How to adjust the height of the Rav4 tailgate
Toyota Rav 4 (2013-2018 / Xa40, MK 4) In this article, we will see how to adjust the opening height of the Toyota Rav4's trunk. The procedure is simple and takes little time to complete.
How to adjust the timing chain on the Toyota RAV 4 VVT-i.
Toyota Rav 4 (2000-2006 / Xa20, MK 2) In today's video, we will see how to properly adjust the timing chain and phase of the Toyota RAV 4 VVT-i engine. The adjustment operation is shown i

How to deactivate the safe lock on a Volkswagen Golf.

The safe lock is indeed an anti-theft system that prevents thieves from accessing the car. This device locks the doors, both externally and internally, when the driver activates the central locking remote control after leaving the vehicle. To permanently disable it, it is necessary to use a diagnostic program such as VCDS that we will connect to the vehicle through the ODBII port. Then wait for the connection and recognition of the control unit and then select the blocks present and locate the safe lock to disable it. And the job will be completed.

Watch the video!


by ScegliAuto

More videos