Do it yourself
| ||||
|
Peugeot 206 - Video tutorial
Model: Peugeot 206
MK 1
- Years 1998-2012 In this short guide we will see the cause of the engine warning light coming on, associated with a catalyst failure, on the Peugeot 206; in particular, the problem seems to concern the lambda probe or the non-functioning oxygen sensor. To solve the problem it is necessary to raise the car and unscrew our lambda probe, located on the exhaust manifold; then disconnect the electrical connector to remove it, as shown in the video. At this point let's install the new original lambda probe, and then reset the engine light using the diagnostic software!
Posted on 25 December 2022 by ScegliAuto
How to replace the ABS sensor and reset the warning light on a Peugeot 206.
Peugeot 206 (1998-2012 / MK 1) Below we will see the steps that will allow us to disassemble and replace the ABS sensor and reset the warning light that appears on the dashboard of
Replace the external temperature sensor of the Peugeot 206
Peugeot 206 (1998-2012 / MK 1) How to remove the temperature sensor of a Peugeot 206? Let's see the disassembly of the sensor from inside the engine compartment. We lift the front
How do you replace the coolant temperature sensor on a Peugeot 206?
Peugeot 206 (1998-2012 / MK 1) The operation to replace the water temperature sensor on the Peugeot 206 is carried out by opening the bonnet, so that you have access to the compone Other guides that may interest you
|
How to reset the oil service in the Fiat Toro?In this tutorial we can see how to reset the oil service in the Fiat Toro. Before carrying out this simple and quick operation, make sure that you have completed any required maintenance work. We start by inserting the key but leaving it in the initial position, after which we keep the accelerator pedal fully depressed and at the same time turn on the instrument panel. At this point, always keeping the accelerator pressed, press the brake pedal 5 consecutive times and, with the pedals in position, turn off the ignition. We check that the procedure has been successful by starting the vehicle. by ScegliAuto More videos
|
For advertising on this site Write to info@scegliauto.com
ScegliAuto is not responsible for any inaccuracy of the data in the lists. To report any inaccuracy or your business (if you own the business in question), please write to info@scegliauto.com
Number of seconds to generate the page: 0.040
(c) ScegliAuto 2024 - info@scegliauto.com - Privacy Policy VAT number: IT01247470535 |