Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Engine Oil and Oil Filter Replacement for Aprilia Sx 125

Model: Aprilia Sx 125
Part: Engine oil

Video tutorial

Follow the steps below to carry out the routine maintenance service by replacing the engine oil and oil filter on the Aprilia Sx 125. First, place the bike on its stand and start by unscrewing the oil drain bolt located under the engine, allowing the oil to drain into a container for about ten minutes; then unscrew the screws of the oil filter cover, removing and replacing the cartridge with a new one (also replace the gasket), as shown in the video.

Finally, pour in the new oil with the correct viscosity (a 5w40).


Updated on 23 June 2026 by ScegliAuto


Related tutorials

How to Replace the Engine Oil and Oil Filter on an Aprilia Sx 125
How to Replace the Engine Oil and Oil Filter on an Aprilia Sx 125
Sx 125 Here are the instructions for replacing the engine oil and oil filter on an Aprilia Sx 125 in simple and quick steps. First, drain the engine oil by …
How to Replace the Engine Oil and Oil Filter on the Aprilia SX 125
How to Replace the Engine Oil and Oil Filter on the Aprilia SX 125
Sx 125 These brief and simple steps will show you how to drain and replace the engine oil and oil filter while performing maintenance on the Aprilia SX 125.…
How to replace the engine oil and oil filter of the Aprilia SX 125
Sx 125 Today we will discover the instructions that will allow us to replace the motor oil and oil filter of the Aprilia SX 125 motorcycle. First, we put th…

How to replace the headlight bulb in the Triumph Tiger 800?

Replacing the headlight bulb in the Triumph Tiger 800, as shown in this tutorial, is an extremely simple and quick operation. First, ensure that the key is not inserted for safety, then locate the large cap on the back of the headlamp and unscrew it. Next, disconnect the power connector by pulling it outwards, unclip the metal clip, and remove the old bulb from the housing. At this point, insert the replacement, avoiding direct contact with the glass, and follow the reverse procedure.

Watch the video!


by ScegliAuto

More videos