Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Replace the Water Pump Cover on the Aprilia SX 125

Model: Aprilia Sx 125

Video tutorial

Here are the instructions to remove and replace the water pump cover on the Aprilia SX 125 enduro bike. First, place your bike on a stand and begin unscrewing the screws securing the metal clamps of the hoses, disconnecting them and allowing the coolant to drain for about ten minutes.

Next, unscrew the screws of the water pump cover as shown in the video. Now, install the new cover, reconnecting the two hoses; finally, pour in the new antifreeze!


Updated on 13 September 2026 by ScegliAuto


Related tutorials

How to Replace the Engine Oil and Oil Filter on an Aprilia Sx 125
How to Replace the Engine Oil and Oil Filter on an Aprilia Sx 125
Sx 125 Here are the instructions for replacing the engine oil and oil filter on an Aprilia Sx 125 in simple and quick steps. First, drain the engine oil by …
Engine Oil and Oil Filter Replacement for Aprilia Sx 125
Engine Oil and Oil Filter Replacement for Aprilia Sx 125
Sx 125 Follow the steps below to carry out the routine maintenance service by replacing the engine oil and oil filter on the Aprilia Sx 125. First, place th…
How to Replace the Engine Oil and Oil Filter on the Aprilia SX 125
How to Replace the Engine Oil and Oil Filter on the Aprilia SX 125
Sx 125 These brief and simple steps will show you how to drain and replace the engine oil and oil filter while performing maintenance on the Aprilia SX 125.…

How to Replace the Headlight Bulbs on the Triumph Speed Triple 765 R?

In this tutorial, you will see how to replace the headlight bulbs on the Triumph Speed Triple 765 R, a very simple and quick operation. First, ensure that the key is not inserted, then locate the large cap at the back of the headlight and remove it by turning it counterclockwise. Next, disconnect the power connector, unclip the metal clip, and remove the old bulb from the housing. At this point, simply insert the replacement and reassemble everything by following the reverse procedure.

Watch the video!


by ScegliAuto

More videos