Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Motorcycles
    2. :
  2. Benelli
    3. :
  3. Tnt 250
    4. : How to change the engine oil of a Benelli TNT 250?

Model: Benelli Tnt 250
Part: Engine oil
How to change the engine oil of a Benelli TNT 250?

To change the motor oil of a Benelli TNT 250, start by warming up the engine for a few minutes to make the oil more fluid. Turn off the engine and place the motorcycle on a central or side stand to ensure stability. Under the engine, locate the oil drain plug. Place a collection tray under the plug to collect the used oil. Use a wrench to loosen the drain plug and let the oil completely drain into the tray. Once the oil is fully drained, put the drain plug back in place and tighten it securely. Now, locate the oil fill plug on top of the engine. Remove the plug and use a funnel to slowly pour the recommended amount of new oil as stated in the owner's manual. Check the oil level with the dipstick to make sure you do not exceed the maximum limit. Once done, replace the fill plug, start the engine for a few minutes, and then turn it off to recheck the oil level, adding more if necessary.


Posted on 23 May 2024 by ScegliAuto



Change the engine oil and oil filter on Benelli TNT 250
Tnt 250 Let's see how to carry out the routine maintenance service, replacing the engine oil and the oil filter, on a Benelli Tnt 250 motorcycle. First of al
How do you replace the engine oil of the Benelli TnT 250?
Tnt 250 The procedure for replacing the motor oil on the Beneli TnT 250 involves loosening the drain plug on the oil pan, located on the bottom of the vehicl
How do you replace the clutch on the Benelli TnT 250?
Tnt 250 In order to replace the clutch of the Benelli TnT 250 you have to loosen the fixing bolts of the crankcase located on the right side of the bike in a

How to change the engine oil of the Kymco Xciting S 400i?

In order to replace the engine oil of the Kymco Xciting S 400i you have to unscrew the oil tank drain plug, which is located in the lower part of the bike: it will be possible to collect all the used oil inside a container suitably positioned. Next to the drain plug it will also be possible to identify the oil filter, which can be extracted from its housing and replaced with a new spare part. After the replacement it will be necessary to top up, inserting the new oil through a funnel from the vent located on the left side of the bike.

Watch the video!


by ScegliAuto

More videos