Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Model: Bmw R1250 Rt
Part: Engine oil

In this tutorial, we can see how to replace the engine oil in the BMW R1250 RT, a very simple and quick operation. First of all, make sure that the engine is sufficiently cold, then remove the left cover to access the filter. Next, locate the drainage hole bolt using a 10mm hex key, let all the oil in the system drain out, and then unscrew the old filter. At this point, all that's left to do is tighten both the replacement filter and the bolt, reassemble everything, and pour the necessary amount of oil through the designated upper hole.

Posted on 22 October 2025 by ScegliAuto

Video tutorial

Related tutorials

How to change the motor oil of a BMW R1250 RS?
How to change the motor oil of a BMW R1250 RS?
R1250 Rt To change the motor oil of a BMW R1250 RS, start by warming up the engine for a few minutes to make the oil more fluid. Turn off the engine and place…
How to Replace the Battery in a BMW R1250 RT?
How to Replace the Battery in a BMW R1250 RT?
R1250 Rt In this tutorial, see how to replace the battery in the BMW R1250 RT, a very simple and quick operation. First, ensure the key is not inserted, then …
Battery replacement on a BMW R1250R
Battery replacement on a BMW R1250R
R1250 Rt Today we will see how to replace the battery of a BMW R1250RT in a few simple steps. Let's start by unscrewing the screw of the panel located on the …

How to Check the Coolant Level in a Yamaha Xmax

In the following video, you will learn how to check the coolant level in a 2008 Yamaha Xmax. First, position the motorcycle on a stable surface by raising the stand. Next, lift the cover located at the top of the motorcycle to access the coolant drain bolt. To top up the coolant, unscrew the cap as shown in the video and add the fluid until it reaches the maximum level, indicated as Max. Once finished, close the valve and refit the cover. At this point, start the engine and let it run at idle for a few minutes to eliminate any air bubbles that may have formed inside.

Watch the video!


by ScegliAuto

More videos