Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions
In this tutorial, we will see how to replace the headlight bulbs on the BMW R1100 RT, a very simple and quick operation. First of all, let's make sure that the key is not inserted, so we can work safely. Then, let's locate the power connector at the back of the headlight in question and disconnect it. Next, we remove the circular rubber cap, unclip the metal fastening clip, and take out the old bulb from its housing. At this point, all that remains is to insert the replacement bulb and reassemble everything by following the reverse procedure.

Posted on 14 December 2025 by ScegliAuto

Video tutorial

Related tutorials

How to Remove the Instrument Cluster on a BMW R1100 RT
How to Remove the Instrument Cluster on a BMW R1100 RT
R1100 Rt This video shows the steps to remove the instrument cluster, including the speedometer and rev counter, on a BMW R1100 RT motorcycle. Start by removi…
Replacement of the clutch cable of the BMW R1100 RT
Replacement of the clutch cable of the BMW R1100 RT
R1100 Rt Today's guide will show us the main steps that will allow us to disassemble and replace the clutch cable of the BMW R1100 RT motorcycle. First of all…
How to replace the motor oil in the BMW R1100 RT?
How to replace the motor oil in the BMW R1100 RT?
R1100 Rt In this tutorial we can see how to replace the motor oil in the BMW R1100 RT, an extremely simple and quick operation. First of all, make sure that t…

How to Check the Coolant Level in a Yamaha Xmax

In the following video, you will learn how to check the coolant level in a 2008 Yamaha Xmax. First, position the motorcycle on a stable surface by raising the stand. Next, lift the cover located at the top of the motorcycle to access the coolant drain bolt. To top up the coolant, unscrew the cap as shown in the video and add the fluid until it reaches the maximum level, indicated as Max. Once finished, close the valve and refit the cover. At this point, start the engine and let it run at idle for a few minutes to eliminate any air bubbles that may have formed inside.

Watch the video!


by ScegliAuto

More videos