Do it yourself
Frequently asked questions about cars and motorcycles

Model: Bmw R1200gs
Part: Brake fluid

Remove the black side panel by unscrewing the T25 Torx screws and connect the socket at this accessible point. Place rags around the front brake cable and unscrew the 8 mm bolt, then unscrew the 1/4" screw. Repeat the process on the other side. On the rear wheel, there is an 11 mm bolt that acts as a cap and a 7/16" screw. Open the reservoir containing the brake fluid to allow air circulation, then bleed the brakes using a flexible tube. Collect the fluid in a container and then add the same amount of oil that has leaked out.

Updated on 6 May 2026 by ScegliAuto

Video tutorial

Related tutorials

R1200gs Today's instructions will show you how to remove and replace the front brake pads on a BMW R1200 GS motorcycle. First, place your motorcycle on a sta…
R1200gs This guide explains how to perform the routine maintenance service for the oil change on the BMW R1200 GS, following these simple steps. First, place…
R1200gs Start by placing your BMW R1200 GS on a motorcycle stand. Next, start the engine and let it run for a few minutes to help the oil drain out. Once you…

How to Replace the Battery in a Yamaha Vino 125 Scooter?

In this tutorial, you will see how to replace the battery in a Yamaha Vino 125 scooter, a very simple and quick operation. First, ensure that the key is not inserted for safety. Then, lift the rubber mat and, using a simple cross-head screwdriver, unscrew the two screws securing the plastic cover. Once opened, disconnect both terminals, starting with the negative, and remove the battery from its housing. To fit the replacement, simply follow the reverse procedure.

Watch the video!


by ScegliAuto

More videos