Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Replacing the Temperature Sensor on the BMW 3 Series

Model: BMW Serie 3 E46 - Years 1998-2006
Part: Engine coolant temperature sensor

This guide will show you how to remove and replace the temperature sensor on the BMW 3 Series, following the instructions below. First, open the hood of your car and start by removing the tubing located at the top; then, loosen the bolts securing the intake manifold to access the temperature sensor, as shown in the video. At this point, remove the securing screw and disconnect the electrical connector to take it out and replace it with the new one (the original); then reassemble everything!

Updated on 20 July 2026 by ScegliAuto

Video tutorial

Related tutorials

Replacing Temperature Sensor on BMW 3 Series
Replacing Temperature Sensor on BMW 3 Series
BMW Serie 3 (1998-2006 / E46) How do you remove the temperature sensor on a BMW 3 Series? Raise the hood of the car to locate the temperature sensor and remove it. Remove the engi…
How to Replace the Temperature Sensor on a BMW 3 Series
How to Replace the Temperature Sensor on a BMW 3 Series
BMW Serie 3 (2005-2013 / E91, E90, E92) This guide will show you how to remove and replace the coolant temperature sensor on a BMW 3 Series. First, open the hood of your car and disconnect …
How to Remove and Replace the Air Temperature Sensor on a BMW 3 Series
How to Remove and Replace the Air Temperature Sensor on a BMW 3 Series
BMW Serie 3 (1998-2006 / E46) Here’s how to remove and replace the air temperature sensor on a BMW 3 Series: Open the hood, lift it, and secure it with the prop rod. Disconnect th…

Where is the Fuel Filter Located in a Volvo XC60?

In this video, you will see where the fuel filter is located in a Volvo XC60 and how to proceed if you need to replace it. As shown, the filter is positioned at the lower part of the engine, right between the left half-shaft and the sway bar attachment. To replace the filter, first, go underneath the vehicle, taking all necessary safety precautions. Then, using an 18mm wrench, open the drain valve and allow any water present to escape. Next, unscrew the housing, remove the old filter, insert the replacement along with a new gasket, and reassemble everything.

Watch the video!


by ScegliAuto

More videos