Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Removing the Clutch Actuator on Ducati Monster 800

Model: Ducati Monster 800

Video tutorial

In this video tutorial, learn how to remove and replace the clutch actuator on a Ducati Monster 800. First, remove the clutch cable by unscrewing the upper bolt; then, pull the clutch a couple of times to clear the tube of any residual oil. Next, unscrew the screws securing the actuator and remove it as shown in the video.

Finally, refit the new actuator, tightening the securing screws, and reconnect the two tubes, adding oil again: follow the video to the end!


Updated on 10 April 2026 by ScegliAuto


Related tutorials

How to Change the Engine Oil on the Ducati Monster 800?
How to Change the Engine Oil on the Ducati Monster 800?
Monster 800 To change the engine oil on the Ducati Monster 800, loosen the bolt located at the bottom of the bike so that all the used oil can be collected in a …
Replacing the Rear Brake Pads on the Ducati Monster 800
Replacing the Rear Brake Pads on the Ducati Monster 800
Monster 800 In today's video, you will see how to remove and replace the rear brake pads on the Ducati Monster 800 motorcycle. First, place your bike on a stand …
How to Replace the Rear Brake Pads on a Ducati Monster 800?
How to Replace the Rear Brake Pads on a Ducati Monster 800?
Monster 800 To replace the rear brake pads on a Ducati Monster 800, loosen the screws that secure the brake caliper to the corresponding sprocket. Once the calip…
ScegliAuto offers an extensive international collection of automotive tutorials available in 12 languages. Each guide combines instructional videos with original explanations written by experienced human editors, along with information about the car models covered.

How to Replace the Engine Mount on the Harley Davidson Dyna?

This brief guide provides instructions on how to remove and replace the engine mount on the Harley Davidson Dyna. First, place your motorcycle on a stand and begin by removing the plastic cover under the engine by unscrewing the fastening screws; then unscrew the bolts of the engine mount attached to the frame, using a jack to lift the engine as shown in the video. At this point, remove and replace the engine mount with the new one, as well as the original; then reassemble everything, following the video tutorial to the end!

Watch the video!


by ScegliAuto

More videos