Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Basic Service on a Ducati Monster

Model: Ducati Monster 800
Part: Checks and maintenance

Video tutorial

Start the engine for a few minutes to warm up all the oil in the circuit. Do not overheat it, or you will struggle to work on it later.

Position a container under the oil compartment and loosen the drain bolt with a ratchet spanner. To avoid spilling oil on the exhaust pipe, which is unfortunately located under the drain hole in this model, place a piece of nylon over it. While collecting the used oil in the container, unscrew the oil filter using the ratchet spanner.

Fit and tighten the new part (lubricate the O-ring) and fill with new oil through the upper fill hole, as shown in the video.


Updated on 25 April 2026 by ScegliAuto


Related tutorials

Removing the Clutch Actuator on Ducati Monster 800
Removing the Clutch Actuator on Ducati Monster 800
Monster 800 In this video tutorial, learn how to remove and replace the clutch actuator on a Ducati Monster 800. First, remove the clutch cable by unscrewing the…
How to Replace the Rear Brake Pads on a Ducati Monster 800?
How to Replace the Rear Brake Pads on a Ducati Monster 800?
Monster 800 To replace the rear brake pads on a Ducati Monster 800, loosen the screws that secure the brake caliper to the corresponding sprocket. Once the calip…
Replacing the Rear Brake Pads on the Ducati Monster 800
Replacing the Rear Brake Pads on the Ducati Monster 800
Monster 800 In today's video, you will see how to remove and replace the rear brake pads on the Ducati Monster 800 motorcycle. First, place your bike on a stand …
ScegliAuto offers an extensive international collection of automotive tutorials available in 12 languages. Each guide combines instructional videos with original explanations written by experienced human editors, along with information about the car models covered.

How to Replace the Exhaust of the MV Agusta F3 675?

To replace the exhaust of the MV Agusta F3 675, loosen the screws securing the right side panel of the vehicle, near the footpeg. Once this panel is removed, you can loosen the screw that secures the clamp connecting the exhaust to the rest of the system. By loosening the screws that hold the old exhaust at the top, you can remove it and replace it with a new one. The new exhaust will then be connected to the system with the fixing ring, secured at the top with the appropriate screw, and then covered with the panel.

Watch the video!


by ScegliAuto

More videos